Echo Type 1E PB-2100 Blower User Manual


 
15
P
OWER
B
LOWER
O
PERATOR
'
S
M
ANUAL
STARTING WARM ENGINE
1. Stop Switch - Start/Run. Move stop switch button (A) away from
the STOP position.
2. Start - Pull Rope. Lay the blower on a flat clear area and pull
the starter handle (D) until the engine fires.
NOTE
If engine does not start after 4 pulls, use Cold Start Procedure.
STOPPING ENGINE
1. Release throttle trigger (E) and allow engine to idle for a minute.
2. Move stop switch (A) to "STOP" position.
WARNING DANGER
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using blower
again.
OPERATING BLOWER
WARNING DANGER
Always wear safety glasses, hearing protection and a face filter
mask or serious personal injury may result.
Do not point the blower pipe in the direction of people or pets.
Read the Safety Section carefully.
IMPORTANT
To avoid engine damage due to over revving, do not block
blower pipe.