Filter
Top Products
POWER EDGER
OPERATOR'S MANUAL
11
DRIVE SHAFT/POWER HEAD
Tools Required: 8mm x 10mm Open End Wrench (PE-2000, PE-2400),
4mm Hex Wrench (PE-3100)
1. Stand engine on a level surface.
2a. (PE-2000/2400) Loosen the two bolts (A) at drive shaft end of
engine.
2b. (PE-3100) Loosen two bolts (A) at drive shaft end of engine and
remove center drive shaft location bolt (B).
3. Carefully fit drive shaft assembly to engine, making sure that inner
drive shaft engages into clutch mount.
NOTE
The line on the drive shaft housing must be in contact with the
engine (arrow on drive shaft indicates line).
4a. (PE-2000/2400) Rotate the drive shaft housing until edger housing is
in line with the engine.
4b. (PE-3100) Rotate drive shaft housing until locating hole lines up with
center location hole in clamp and install center bolt (B).
5. Tighten bolts (A).
THROTTLE LINKAGE
Tools Required: 8mm x 10mm Open End Wrench (All Models), 3mm
Wrench (PE-2400)
1. Close choke and remove air filter cover.
2. Loosen nut (A) and place threaded end of throttle linkage in
bracket slot. Finger tighten nut (A). Place inner cable in slot of
carburetor (B).
3. Check throttle action, for freedom of movement and that the inner
throttle linkage allows the carburetor throttle plate (E) to return to
idle stop. Adjust cable nut counter clockwise to increase inner
throttle lnkage length and allow throttle plate to rest against stop.
4. Tighten nut (A).
A
A
A
B
PE-2400
PE-3100
PE-2000
PE-2000
A