Filter
Top Products
PE-280 ASSEMBLY
X7502310607 13
© 02/2014 ECHO Inc.
ASSEMBLY
Drive Shaft/Power Head
1. Stand power head upright on a level surface.
2. Loosen the drive shaft clamp bolt (A) at engine drive shaft
clamp.
3. Remove dust cap and carefully fit drive shaft assembly to
engine making sure that inner drive shaft engages into
clutch mount.
Note: Gear Housing must be aligned properly with engine.
4. Tighten drive shaft clamp bolt (A) securely.
5. Route throttle linkage and ignition lead assembly below fan
housing.
Throttle Linkage and Ignition Leads
1. Close choke and remove air filter cover.
2. Place inner throttle cable in large hole of carburetor swivel
(A).
3. Loosen nuts (B) and place threaded end of throttle linkage
in bracket slot. Finger tighten nuts (B).
4. Check throttle for freedom of movement and that wide open
throttle / low idle extremes are adjusted properly. If
adjustment cannot be achieved with adjusting nuts (B),
consult with your Echo Dealer for correct adjustment
procedure. Tighten nuts (B).
5. Connect 2 ignition stop leads (C,D) from throttle cable
tubing to 2 ignition leads (C,D) on engine.
Parts Required: Power Head, Drive Shaft Assembly
I
A
A
B
C
D