Filter
Top Products
Power edger
oPerator's Manual
17
aIr fIlter
Level 1.
Parts required: REPOWER
TM
Air & Fuel Filter Kit.
1. Close choke (Cold Start Position [
]). This prevents dirt from
entering the carburetor throat when the air lter is removed. Brush
accumulated dirt from air cleaner area.
2. Remove air lter cover. Brush dirt from inside cover.
3. Remove air lter and lightly brush debris from lter. Replace lter
if it is damaged, fuel soaked, very dirty, or the rubber sealing edges
are deformed.
4. If lter can be reused, be certain it:
• Fits tightly in the air lter cavity.
• Is installed with the original side out.
5. Install air lter cover.
fuel fIlter
Level 1.
Parts required: REPOWER
TM
Air & Fuel Filter Kit.
DANGER
Fuel is VERY ammable. Use extreme care when mixing, storing
or handling.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and lter from the
tank.
3. Remove the lter from the line and install the new lter.
NOTE
Federal EPA regulations require all model year 2012 and later gasoline powered engines produced for sale in the United
States to be equipped with a special low permeation fuel supply hose between the carburetor and fuel tank. When servicing
model year 2012 and later equipment, only fuel supply hoses certied by EPA can be used to replace the original equip-
ment supply hose. Fines up to $37,500 may be enforced for using an un-certied replacement part.