Filter
Top Products
13
Power Blower
oPerator's Manual
PB-755ST
WARNING
Never perform maintenance or assembly procedures with engine
running or serious personal injury may result.
InsTall blower pIpes (T)
1. Place guide loop (G) across large clamp, and turn until clip fully
engages clamp band.
NOTE
Clamp with cable guide loop (G) ts large end of exible pipe (B).
2. Assemble clamps (A) onto both ends of exible pipe (B).
3. Assemble exible pipe (B) to elbow (D) on blower. Position
guide loop (G) on inside (blower side) of exible tube and tighten
clamp (A).
NOTE
A light lubricant may be used to ease assembly of exible pipe to
blower elbow.
NOTE
Hang handle freely from blower to assure throttle cable is not
twisted before installing handle (E).
4. Position cable between the elbow (D) and frame and along the top
of the exible pipe. Loosen knob (H) on handle (E). Align notch
in handle with tabs (F). Install onto swivel pipe (C) past long
ridges in pipe.
5. Assemble swivel pipe (C) into exible pipe (B) and tighten clamp
(A).
6. Clip throttle cable into throttle cable guide loop (G).
7. Move handle (E) to desired position. Tighten knob (H) hand tight.
8. Assemble straight pipe (I) onto swivel pipe (C), until you feel
light resistance. Do not force connection. Hold swivel pipe and
turn straight pipe clockwise, engaging positive locking channels,
until connection is rm. Do not force connection.
9. Assemble straight pipe with decal (J) to straight pipe (I) as in step
8.
NOTE
Blower use will eventually loosen pipe connections. Exclusive
positive locking system allows pipes to be tightened. If loosening
occurs, remove two straight pipes and install according to instruc-
tions 8 & 9.
G
G
E
B
H
F
D
G
A
A
B
C
G
E
I
J
C
E
H