Filter
Top Products
19
Po w e r Bl o w e r
oP e r a t o r 's Ma n u a l
IMPORTANT
Carbon deposits in mufer will cause a drop in engine output and
overheating. Spark arrestor screen must be checked periodically.
1. Remove spark plug lead from spark plug, and remove engine or
mufer cover (5 screws).
2. Remove spark arrestor cover (A), gaskets (B) and spark arrestor
screen (C) from mufer.
3. Clean carbon deposits from mufer components.
NOTE
When cleaning carbon deposits, be careful not to damage the cata-
lytic element inside mufer.
4. Replace screen if it is cracked, plugged, or has holes burned
through.
5. Install engine cover or mufer cover and attach spark plug lead.
B
C
A
Exhaust Port Cleaning
Level 2.
Tools required: 4 & 5 mm Hexagon wrench, Cross head screwdriver,
Wood or plastic scraper
Parts Required: As needed: Heat Shield
1. Remove spark plug lead from spark plug, and remove engine or
mufer cover (5 screws).
2. Place piston at top dead center. Remove mufer (A) gasket (B),
and heat shield (C).
3. Use a wood or plastic scraping tool to clean deposits from cylinder
exhaust port.
IMPORTANT
Never use a metal tool to scrape carbon from the exhaust port.
Do not scratch the cylinder or piston when cleaning the exhaust
port. Do not allow carbon particles to enter the cylinder.
4. Inspect heat shield (C) and gasket (B) and replace if damaged.
5. Install heat shield (C), gasket (B), and mufer (A).
6. Tighten mufer mounting bolts (or nuts) to 110-130 in•lbf
(130-150 kgf•cm).
7. Install engine cover.
8. Attach spark plug lead.
9. Start engine, and warm to operating temperature.
10. Stop engine, and re-tighten mounting bolts (or nuts) to specica-
tions.
A
B
C