Echo PB-46HT Blower User Manual


 
10
1. AIR CLEANER - Contains replaceable air filter element.
2. SPARK PLUG - Provides spark to ignite fuel mixture. Spark plug is located under the cover on LN models.
3. MUFFLER/SPARK ARRESTOR -The spark arrestor muffler controls the exhaust noise while the spark
arrestor prevents hot, glowing particles of carbon from leaving the muffler where they could possibly start a fire.
4. SERIAL NUMBER LABEL - Located on underside of unit below starter housing. Lists model number and
serial number of unit. If unit is emission certified, label identifies unit as TYPE 1E.
5. RECOIL STARTER HANDLE - Pull recoil handle slowly until starter engages, then quickly and firmly. When
engine starts, return handle slowly. DO NOT let handle snap back or damage to unit will occur.
6. PRIMER BULB - Pumping primer bulb before starting engine draws fresh fuel from the fuel tank priming the carburetor for
starting. Pump the bulb 10 times until fuel is visible in clear fuel return line.
7. CHOKE - Move lever DOWN to close choke (starting position) and for emergency stopping. Move UP to open
choke (run position).
8. FUEL TANK CAP - Covers and seals fuel tank.
9. THROTTLE POSITION LEVER/STOP SWITCH - Combination stop switch and variable speed throttle lever.
When the lever is moved all the way forward the blower is at Wide Open Throttle (W.O.T.). When the lever is
moved rearward to detent, the blower is at idle. When the lever is moved rearward past the idle detent the blower
will stop.
10. SAFETY DECAL - Lists important safety precautions.
11. HANDLE - Rotates downward for throttle control access. Spring loaded for flexible operation.
12. SHOULDER HARNESS - Used to support unit on operator's back. The straps are adjustable.
13. BLOWER PIPES - Twist lock design.
14. FLEXIBLE PIPE - Allows for full range of movement.