Filter
Top Products
19
POWER BLOWER
OPERATOR'S MANUAL
AIR FILTER
Level 1.
Tools required: 25 - 50 mm (1 - 2 in.) medium bristle paint brush.
Parts required: Tune Up Kit P/N 90070
NOTE
Clean daily.
1. Close choke (Cold Start Position). This prevents dirt from
entering the carburetor throat when the air filter is removed.
Brush accumulated dirt from the air cleaner area.
2. Remove the air cleaner cover. Clean and inspect the element for
damage. If element is fuel soaked and very dirty, replace.
3. If element can be cleaned and reused, be certain it:
-still fits the cavity in the air cleaner cover.
-is installed with the original side out.
FUEL FILTER
Level 1.
Tools required: Fuel line hook. 200-250 mm (8 - 10 in.) length of wire
with one end bent into a hook, clean rag, funnel, and
an approved fuel container.
Parts required: Tune Up Kit P/N 90070
WARNING DANGER
Fuel is VERY flammable. Use extreme care when mixing, storing or
handling.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and filter from the
tank.
3. Remove the filter from the line and install the new filter.