Filter
Top Products
22
shARpeNING blAdes
Level 2.
Parts required: None
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.
1. Disconnect spark plug wire.
2. Slide blades to allow le clearance using slots on bottom of blades.
Do not pry against cutting edges.
3. Follow the original shape, and le each cutting edge carefully to
avoid damage to adjacent teeth. Maintain 6 mm (.25 in.) radius at
base of each tooth.
IMPORTANT
If a power grinder is used, DO NOT allow blade to over heat.
4. Lubricate blades. See "Lubrication".
5. Connect spark plug wire.
Gear Box Assembly
Level 1.
Parts required: POWER BLENDX
TM
14 oz. or Lithium Based
Grease.
1. Clean dirt from grease tting.
2. Apply 1-2 pumps of grease into tting, DO NOT over ll. Leave
room for the grease to expand during operation.
6 mm
(.25 in.)
Radius
45°