Filter
Top Products
21
The following combinations may be used on CS-330T and CS-360T.
CHAIN AND GUIDE BAR COMBINATIONS
*Reduced nose radius symmetrical bars (OREGON name — Double Guard)
LEDOM
RAB
HTGNEL
KCABKCIKWOL
RABDRAUG
NIAHCWASKCABKCIKWOL
KCIK
DRAUG
N/PRAB
NIAHC
.ONTRAP
SKNILEPYTHCTIPEGUAG
N/POHCE
)N/PMEO(
T033-SC
T063-SC
"21
"41
"61
5473DE0A21
2573DE0A41
7573DE0A61
54-GV19
25-GV19
75-GV19
54
25
75
GV19"8/3050.
10
94982
94982
WARNING DANGER
Use of replacement saw chain and/or guide bar other than that specified, or operation without the “tip guard” in place, may
cause severe kickback resulting in serious injury.
Only use saw chain designated as, “LOW-KICKBACK,” that meets the ANSI B175.1-2000 Standard when tested on the
representative sample of chain saws below 3.8 C.I.P. specified, and the Echo guide bar specified.
IMPORTANT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table
above.
IMPORTANT
If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the name
of the Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at www.echo-
usa.com.
Refer to your Chain Saw Safety Manual for kick guard application information.