Echo 2CS-450 Chainsaw User Manual


 
26
CS-450
Oil lter
Fuel lter
Oil tank cap Fuel tank cap
0.65 mm (0.026 in.)
AIR FILTER
Check before every use.
Loosen cleaner cover knob and remove air
cleaner cover and lter.
Brush off dust lightly, or clean with compressed
air, or replace the air lter.
Reinstall air lter and cover.
CHECK FUEL SYSTEM
Check before every use.
After refueling, make sure fuel does not leak
from around fuel pipe, fuel grommet or fuel tank
cap.
In case of fuel leakage there is a danger of re.
Stop using the machine immediately and re-
quest your dealer to inspect or replace.
SPARK PLUG
Check periodically.
The standard spark gap is 0.65 mm
(0.026 in.).
Correct the spark gap if it is wider or
narrower than the standard gap.
Fastening torque: 15 to 17 N·m
(130 to 145 in. lb.).
FUEL FILTER
Check periodically.
Do not allow dust to enter fuel tank.
A clogged lter will cause difculty in starting
engine or abnormalities in engine performance.
Pull the fuel lter out through fuel inlet port with
a piece of steel wire or the like.
When the lter is dirty, replace it.
When the inside of the fuel tank is dirty, rinsing
the tank out with gasoline can clean it.
OIL FILTER
Check periodically.
Do not allow dust to enter into oil tank.
A clogged oil lter will affect the normal lubricat-
ing system.
Pull it out through oil lling hole with a piece of
steel wire or the like.
If the lter is dirty, wash it in gasoline or replace
it.
When the inside of the tank gets dirty, rinsing
the tank out with gasoline can clean it.
Cleaner cover knob
Spark plug
Air cleaner cover
Air lter
Cylinder cover
Air lter cover