Echo 211 Trimmer User Manual


 
99944200610 ASSEMBLY
X7702273508 13
© 4/2015 ECHO Inc.
1. Place the shield on the bottom of the bearing housing
flange.
2. Place shield plate (B) on shield, align holes. Install three (3)
screws from bottom through plate and shield into gear case.
Nylon Line Head Installation/Removal
1. Align hole in upper plate with notch in edge of gear housing
and insert head locking tool (A). Remove plastic sleeve from
PTO shaft.
2. Be sure upper plate (B) remains on PTO shaft.
3. Place line head onto PTO shaft, followed by large metal
washer (C).
4. Thread L.H. nut (D) on PTO shaft. Tighten securely.
5. Install new split pin (E).
6. Remove locking tool (A).
7. To remove line head, reverse assembly instructions.
C