Filter
Top Products
99944200485 MAINTENANCE
X7702091904 15
© 08/2013 ECHO Inc.
1. Brush loose debris from blade and coat both sides of blade
with the 50-50 cleaning mixture.
2. Allow cleaning mixture to soften the remaining gummy
residue then wipe it from the blade.
3. Apply clean oil to the entire length of the blade. Be certain
the blade bolts are lubricated.
4. Wipe excess oil from the blade before putting the unit back
in service.
Gear Housing Assembly
Level 1.
1. Clean dirt from the grease fitting (A).
2. Carefully pump grease into fitting (A). DO NOT force
grease. Too much pressure will force grease past seals and
cause damage. Apply 1-2 pumps of grease every 15-25
hours of operation.
3. Wipe excess grease from around grease fitting.
Drive Shaft Assembly
Level 1.
Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid
touching blades whenever possible, and always wear gloves to protect hands.
1. Remove gear housing locating screw (A) and loosen
clamping screw (B). Remove the gear housing assembly
from the drive shaft housing..
2. Pull the drive shaft (C) from the housing, wipe clean and
re-coat with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the drive shaft back in the drive housing being careful
not to get dirt on the flex shaft.
Parts Required:
POWER BLENDX
TM
14 oz. or Lithium Base
Grease.
Parts Required:
POWER BLENDX
TM
8 oz. or Lithium Base
Grease.
A
A
B
C