Earthquake Sound ROTOTILLERS Tiller User Manual


 
OPERATING INSTRUCTIONS AND PARTS EXPLOSIONS
Front Tine Models
Page 5800-345-6007
IMPORTANT
THE RIGHT AND LEFT SIDES OF
YOUR ROTOTILLER ARE DETER-
MINED FROM THE OPERATING POSI-
TION AS YOU FACE THE DIRECTION
OF FORWARD TRAVEL.
ENGINE IS SHIPPED FROM FACTORY
WITHOUT OIL. YOU MUST ADD EN-
GINE OIL BEFORE STARTING ENGINE.
c. Fill fuel tank outdoors with extreme care. Never fill fuel
tank indoors.
d. Replace gasoline cap securely and clean up spilled fuel
before restarting.
Never attempt to make any adjustments while the engine is
running.
OPERATION
Do not operate the tiller under the influence of alcohol or
drugs.
Never operate the tiller without guards, covers, and hoods in
place.
Keep hands, feet, and clothing away from rotating parts. Keep
clear of tiller tines at all times.
Tines rotate when tiller is engaged, tines rotate when the drive
safety control lever is pulled down. Releasing the drive safety
control lever to neutral stops the tines.
Use extreme caution when operating on or crossing gravel
drives, walks, or roads. Stay alert for hidden hazards or
traffic.
After striking a foreign object, stop the engine, remove the
wire from the spark plug, thoroughly inspect the tiller for
any damage, and repair the damage before restarting and
operating the tiller.
If vegetation clogs the tines, STOP THE ENGINE AND
DISCONNECT THE SPARK PLUG WIRE before removing
vegetation by hand.
Engine muffler will be hot from operation. Do not touch it with
bare skin or a severe burn may result.
If the unit should start to vibrate abnormally, stop the engine
and check immediately for the cause. Vibration is generally a
warning of trouble.
Do not run the engine indoors; exhaust fumes are deadly.
Do not overload the machine capacity by attempting to till too
deep at too fast a rate.
Never allow bystanders near the unit.
Never operate the tiller without good visibility or light.
Be careful when tilling in hard ground. The tines may catch in
the ground and propel the tiller forward. If this occurs, let go
of the handlebars and do not restrain the machine.
Take all possible precautions when leaving the machine
unattended. Disengage all control levers, stop the engine,
wait for all moving parts to stop, and make certain guards
and shields are in place.
When leaving the operating position for any reason:
- shut off the engine.
- wait for all moving parts to stop.
MAINTENANCE AND STORAGE
Keep machine, attachments, and accessories in safe working
condition.
Check shear bolts, engine mounting bolts, and other bolts at
frequent intervals for proper tightness to be sure the equipment
is in safe working condition.
To prevent accidental starting, always disconnect and secure
the spark plug wire from the spark plug before performing tiller
maintenance.
Never run the engine indoors. Exhaust fumes are deadly.
Always allow muffler to cool before filling fuel tank.
Never store equipment with gasoline in the tank inside a closed
building where fumes may reach an open flame or spark. Allow
the engine to cool before storing in any building.
Always refer to the operator’s guide instructions for important
details if the tiller is to be stored for an extended period.