Filter
Top Products
32
12
7
8
9
10
11
Replacing the fuel lter
The felt lter (12) of the fuel lter can become clogged.
It is recommended to replace the fuel lter once every
three months in order to ensure unimpeded fuel ow to the
carburetor.
To remove the fuel lter for replacement, pull it out through
the tank ller neck using a piece of wire bent at one end to
form a hook.
C
D
Cleaning the air lter
Unscrew screw (14) and remove the lter cover (13).
IMPORTANT: Cover the intake opening with a clean cloth in
order to prevent dirt particles from falling into the carburetor.
Remove the air lter.
CAUTION: To prevent injury to the eyes, do NOT blow out
dirt particles! Do not use fuel to clean the air lter.
Clean the air lter with a soft brush.
If the lter is very dirty, clean it in lukewarm water with dish-
washing detergent.
Let the air lter dry completely.
If the lter is very dirty, clean it frequently (several times a day),
because only a clean air lter provides full engine power.
CAUTION:
Replace damaged air lters immediately.
Pieces of cloth or large dirt particles can destroy the en-
gine!
E
13
14
Replacing the saw chain
CAUTION: Use only chains and guide bars designed for
this saw (see the Extract from the spare-parts list)!
Check the sprocket (7) before mounting a new chain.
Remove the sprocket guard (see ”PUTTING INTO OPERATI-
ON” A-H)
CAUTION: Worn out sprockets (8) may damage the new chain
and must therefore be replaced.
Replacing the clutch drum and sprocket
Release the chain brake if necessary.
Lever off the circlip (11) using the universal wrench and remove
the washer (10).
Pull off the clutch drum together with the sprocket (9) and t a
new clutch drum and sprocket in reverse order.