Dolmar MS-22C Trimmer User Manual


 
10
Turn the machine upside down, and you can replace the nylon cutting head.
Insert the hex wrench through the hole in the gear case and rotate the
receiver washer (3) until it is locked with the hex wrench.
Loosen the nut (1) (left-hand thread) with the socket wrench and remove
the nut (1), and clamp washer (2).
NOTE:The clamp washer (2), and nut (1) are not necessary for mounting the
nylon cutting head. The nylon head should go on top of the receiver
washer (3).
Screw the nylon cutting head onto the shaft.
Make sure that the blade is the left way up.
MOUNTING OF NYLON CUTTER HEAD
Rotation
Hex wrench
Tighten
Loosen