Filter
Top Products
CONTROLS
20
MOWER BLADE SWITCH:
To engage blades: pull up on switch
To disengage blades: push down
IGNITION SWITCH:
•Turn to start position to crank engine.
Release when it starts.
•For headlights - rotate switch one notch
counter-clockwise from run.
Note: Remove key when mower is not in use.
CHOKE CONTROL LEVER:
•Located on the control panel to the operator’s right.
THROTTLE CONTROL LEVER:
•Located on control panel to operator’s right.
•Controls engine speed.
•While mowing, throttle control should be set to MAXIMUM
or wide open setting to insure adequate cooling of the
engine and to maintain mower deck blade speed.
CIRCUIT BREAKER:
•If circuit breaker pops up, it disconnects the power. Wait 2
minutes and push to reset.
•If it pops up again, there is a short circuit. Stop and find
fault or contact your dealer.