17
CONTROLS
MOWER BLADE SWITCH:
Located on the control panel to the operator’s right.
To engage blades: pull up on switch
To disengage blades: push down
CHOKE CONTROL LEVER:
Located on control panel to operator’s left.
Use to start a cold engine.
THROTTLE CONTROL LEVER:
Located on control panel to operator’s right.
Controls engine speed, slow
to maximum.
While mowing, throttle control should be set to MAXIMUM or
wide open setting to insure adequate cooling of the engine and
to maintain mower deck blade speed.
CIRCUIT BREAKER:
Located on control panel to the operator’s right.
Protection of the
electrical system is by (2) 30 amp circuit breakers.
If circuit breaker trips, push button to reset.
If condtion repeats, consult dealer for inspection and repair.
MOWER DECK CUT HEIGHT LIFT LEVER:
Located to the right and front of the operator.
Controls the cutting height.
Nine positions of adjustment.
Depress trigger and move lever forward to lower deck.
Depress trigger and pull lever back to raise deck.
Note: To achieve a 1” to 3” cutting range, the bar connecting the deck
lift handle and the rear of the deck must be in the first hole. To
achieve a 3” to 5” range, the bar connecting the deck lift handle
and the rear of the deck must be in the second hole.
Note: Always use high position for transport.