Filter
Top Products
CONTROLS:
BLADE DRIVE: Models ZTR 3303 - ZTR 3304
Located to left of operator.
To engage the mower blade, turn lever on
floor slowly to the "ON" position.
To disengage mower blade, turn lever to the
"OFF position.
BLADE DRIVE: Model ZTR 3014
Located on control panel, on operator's right.
To engage the mower blades, lift switch up
lightly and push forward.
To disengage blades, pull switch backward.
Switch is clearly marked "on" and "off".
MOWER DECK CUT HEIGHT LIFT LEVER:
Located to left of operator. Controls the
cutting height. Seven positions of
adjustment. Move lever in and forward to
lower. Move lever in and back to raise.
NOTE: Always use high for transport.
CIRCUIT BREAKER:
Protection of the electrical system is by (1)
15 amp circuit breaker.
If circuit breaker trips, push button to reset.
If this condition repeats, consult dealer for
inspection and repair.
Page 15