Filter
Top Products
Page 2
"IMPORTANT" - PERFORM SAFETY CHECKS AFTER MAKING ANY REPAIRS OR ADJUSTMENTS
1. After reassembly, while seated on mower attempt to start engine with mower
deck engaged. Engine should not start. If engine does start, return the mower
to an Authorized Dixon Dealer for adjustment or repair.
2. Disengage mower deck and start engine. With the operator in the normal
seated position, engage mower deck and remove weight from seat. The engine-
should stop. If the engine does not stop when operator rises from seat, return the
mower to an Authorized Dixon Dealer for adjustment or repair.
3. Engage, then disengage, mower blade in each cutting height. Insure that
blade disengages and comes to a stop within (5) seconds in each height position.
If blade does not disengage properly contact your Authori zed Dixon Dealer.
PARKING BRAKE ADJUSTMENT
1. Raise upper body to the open position.
2. Tighten nut on brake rod (P/N 2533) located in front of the transaxle
on each side, just enough to prevent brake from slipping when engaged.
CAUTIQN: Over tightening may cause premature wear on the brake bank (P/N
5085).
REMOVING THE MOWER BLADE
Secure blade (P/N 2483) from turning. Remove blade bolt from center (P/N
3268), lock washer (P/N 3065) and blade washer (P/N 6113), then blade (P/M
2483). To reinstall, reverse above procedure. . WARNING; Sharp edges on
blade can cause injury!
Caution should be exercised when service is required on blade.
(P/N 8112)
DIXON INDUSTRIES, INC.
Box 1569
Coffeyville. Kansas 67337
-
0945 (316) 251
-
2000 Airport
I
ndustrial Park
TELEX: 417109