Filter
Top Products
Page 15
SPECIFICATIONS
Model ZTR 3303
CHASSIS: Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
BODY: All body parts are made of rotational molded polyethylene. Front body contains
access panel for battery service. Seat tilts forward to allow transmission service.
MOWER DECK: 11 GA stamped steel construction.
Single 30" cut blade.
Cut height approximately 1" to 4" via 7 position lift handle.
BLADE DRIVE: Mechanical; hand lever engagement.
TRANSMISSION: Each rear wheel is independently driven by chain and sprockets through a
friction mechanical drive.
ENGINE: 10.5 HP I/C Briggs & Stratton, 4-Cycle, Single Cylinder, Air-Cooled, Gasoline,
Vertical Shaft, Aluminum Head and Block.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake and
blade drive.
TIRES: Front 11 X 4.00-5 ribbed tread.
Rear 16 X 6.50 X 8 Turf Trac R/S tread.
RECOMMENDED Front 16-21 PSI
TIRE PRESSURE: Rear 8-14 PSI
CAPACITIES: Fuel 2.0 gallons total.
Engine 1.25 quarts oil.
DIMENSIONS: Width 32.5" outside rear wheel measurement.
Height 32.0" to top edge of seat.
Length 65.5" hitch tab to front bumper.
Weight 430 lbs.
NOTE: Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.