Dixon ZTR34/968999619 Lawn Mower User Manual


 
English-33
OPERATION
Moving by Hand
When pushing or pulling the mower, be sure to engage
the IZT (Integrated Zeroturn Transaxle) bypass
linkages.
Always turn off engine before engaging or
disengaging the hydro release. Never
attempt to adjust the bypass linkages with the
engine running.
The hydro release valves are located below
the seat, on the front side of the hydro
pumps.
Raise the deck into the highest cutting
position.
Lift the seat frame assembly to access the
release valves.
Use a
5
/8" wrench to rotate bolt counter-
clockwise two full turns to disengage pump.
Repeat the procedure for the opposite pump.
To engage, rotate each pump bolt clockwise
until the bolt is snug. Do not overtighten the
release valve or damage to the hydro pump
could occur.
WARNING!
Make no adjustments without:
the engine stopped
the ignition key removed
the parking brake activated
1. Left hydro gear
2. Release valve
Bypass linkages
8050-767
1
2