Dixon RAM 44 Lawn Mower User Manual


 
CARE AND MAINTENANCE
44
Hex Head
Valve Stem
CHANGING THE ENGINE OIL
1. The “Dapco” oil drain valve is located on the left side of
the engine crankcase.
2. Place a suitable container under the drain valve hose.
3. To drain, turn hex head valve stem counter-clockwise with
a 10mm wrench or socket. Open to full open
(approximately 7 turns).
4. After engine is drained, tighten hex stem.
5. Change oil filter.
6. Fill with oil (see steps below).
NOTE: Refer to engine manufacturer’s recommendations for
frequency of oil changes.
OIL FILL
1. Clean any spilled oil from engine and chassis.
2. Refill engine with type, and quantity of oil recommended
by the engine manufacturer in engine literature.
NOTE: Engine oil changes on the Ram Series will require
replacement of the oil filter. These filters may be available
from your local Dixon Dealer.
CAUTION
HOT oil may cause burns. Allow engine to
cool before draining oil.
!
Fig. 9