Dixon 966 004201 Lawn Mower User Manual


  Open as PDF
of 18
 
8
ASSEMBLY
1
INSTALLING BAGGER MOUNT
Install the bagger mount tube to the rear guard 1.
with
5
/16-18x3¼boltsandangenutsfromkit.
NOTE: Depending on model, rear guard hole may
need to be drilled out to
5
/16"ifkithardwareistoo
large.
Installkitsupportstrapsontheoutsideofthe2.
mount tube as shown in the illustration. Using a
5
/16-18 x 1¼ bolt, attach the front side of the strap
tothefendersupport.Donotaddangenutatthis
time. Place the reinforcement plate to the outside
of the fender support. Secure with additional 1¼
boltandfastenbothboltswithangenuts.Repeat
steps on opposite side.
NOTE:Thefrontsideofthekitsupportstraps
should be on the inside of the mower frame.
Tighten all hardware. 3.
Reinforcement Plate
Mount Tube
Support Strap
Drill rear
guard hole to
5
/16" if needed
1. Position upper chute support against bagger inlet,
ushatouteredges.SeeIllustration.
2. Using support as a template, drill two
3
/8 holes into
bagger hood.
Upper Chute Support
Bagger Inlet
Nut
Bagger Hood
Flat Washers
Hex Bolt
Flex Trim
3. Secure upper chute support to hood with hex
bolts, washers and nyloc nuts.
2
INSTALLING CHUTE SUPPORT
 previous next