Dixon 966412801 Blower User Manual


 
6
Remove the discharge chute from the deck. (Deck 1.
conguration will vary by size and model)
Lower deck to the lowest cutting position.2.
Remove the right hand (discharge side) belt cover 3.
from the deck.
Relieve the tension from the deck belt and remove 4.
from the center deck pulley.
(See Operator’s Manual if necessary)
ASSEMBLY
1
INSTALLING DRIVE PULLEY
2
MOUNTING BLOWER ASSEMBLY
Outer Pulley Cover
Bolt
Nut
Rear Mount Bracket
Contact Area
Remove the nut securing the right hand deck 5.
pulley to the spindle.
Install drive pulley included in collection system kit 6.
on top of the current deck pulley.
Reinstall the nut on the spindle and torque to 55-7.
75 ft/lbs.
Reinstall the deck belt.8.
Deck Height Adjustment
Belt Cover
Discharge Chute
Drive Pulley
Position blower over the discharge tabs on the 1.
deck and set blower onto the deck.
Be sure the blower is sitting ush against the 2.
outside of the deck.
Install the front mount bracket to the deck with the 3.
bolt, washers and nut supplied with the kit.