Filter
Top Products
12. Install all-thread hex head bolts into seat straps.
Place (1) 5/16-18 x 3" bolt through hole located 1-
5/8" from end of strap. Place (1) 5/16-18 x 4" bolt
through hole located 2-7/8" from opposite end of
strap. Secure each bolt to strap using (1) 1/8"
thick washer and (1) 5/16-18 hex nut w/nylok. See
illustration. Repeat procedure for other seat strap.
13. Attach seat straps to seat bottom as illustrated.
The 3" stud protruding through strap must be
located near the rear of seat while the 4" stud
should be nearest the front edge of seat. Align
remaining seat strap holes with holes in bottom
of seat as shown, and attach seat straps using
(4) 5/16-18 X 1" tapping screws.
14. Place seat assembly on body, and
connect safety switch.
15. Place (1) seat spacer (1849) on each stud
protruding through seat bottom, and insert studs
through slots in body. Firmly hold seat assembly
against body with one hand while body is raised
to fully open position. Continue to hold seat
against body to prevent damage to seat safety
switch wiring.
1 6. Install (1 ) 5/1 6 standard flat washer (3020), (1)
seat knob (3874), and (1) nylok nut (3205) on
each of the front studs extending through body
and seat frame, and tighten these nuts.
17. Install (1) 5/16 standard flat washer (3020) and (1)
nylok nut (3205) on each of the rear studs. Do not
fully tighten these nuts, thus allowing for easy
slide action of seat, as provided by knobs on front
studs.
Page 8
SEAT ASSEMBLY INSTRUCTIONS: