Filter
Top Products
11
ASSEMBLY
5
INSTALLING MIDDLE CHUTE
MIDDLE CHUTE
BLOWER ASSEMBLY
Depending on model, engine guard may have
available mounting holes. If drilling is needed, use
template supplied with kit.
1. Attach template to engine guard at the
corresponding holes as shown in illustration.
With centerpunch, transfer the four
1
/8" bagger
mount holes to the engine guard.
2. Remove template and drill four
11
/32" holes in
engine guard at locations marked in Step 2 .
6
INSTALLING BAGGER MOUNT
3 Bin Collector
MOUNT STRAP
MOUNT TUBE
MOUNT STRAP
RAM MOUNT
1
/8" DIAMETER HOLES
3. Install the bagger mount tube from the mount kit.
ENGINE GUARD
3. Remove the front carriage bolts securing the
engine guard.
4. Install kit mount straps between the mount tube
and frame as shown in the illustration. The front
side of the kit mount straps should be on the
inside of the mower frame.
5. Tighten all hardware.
KIT MOUNT STRAP
KIT MOUNT STRAP
RAM ULTRA MOUNT
1. Place middle chute over the top end of the
blower assembly.
2. Latch middle chute to blower assembly.
TEMPLATE ATTACHMENT
MOUNT TUBE