Filter
Top Products
8
ASSEMBLY
1
BAGGER SUPPORT ASSEMBLY
2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY
NOTE: For ease of assembly, you may wish
assistance from another person for mounting the
cover assembly to mower.
1. Position cover assembly on ground behind
mower .
2. Lift and rotate cover to align cover bracket
with hanger bracket and slide down until
secure.
Existing Hardware
Guard Reinforcement
Hanger Bracket
Drill two
11
/32
holes into engine
guard to match
these holes
Engine Guard
Frame Bracket
Hanger
Bracket
1. Remove the two upper side bolts on the
engine guard as illustrated. Set hardware
aside for reuse.
2. Attach guard reinforcement to engine guard
using hardware removed in Step 1.
3. Attach hanger bracket to guard reinforcement
with two
5
/16 x ¾ carriage bolts and two
5
/16
nyloc nuts. See illustration.
4. After the hanger bracket is attached to the
guard reinforcement, two holes will need to be
drilled through the engine guard for the
matching bottom holes of the hanger bracket.
5. Use the bottom hanger bracket holes as a
template to drill the two
11
/32 holes.