Dixon 44 / 968999547 Brush Cutter User Manual


 
CONTROLS
English-20
4. Refueling
The machine has one fuel tank, just behind the seat.
The tank capacity is 4.5 gallons (17 liters).
The engine will run on a minimum of 85-octane
unleaded gasoline (no oil mix). Environmentally
adapted alkylate gasoline can be used. See also
Technical Data concerning ethanol fuel. Methanol fuel
is not allowed.
When operating below 32°F (0°C) use fresh, clean
winter grade gasoline to help insure good cold weather
starting.
Fuel tank
8050-768
WARNING!
Gasoline is highly flammable.
Observe caution and fill the tank
outdoors. (See Safety)
WARNING!
Fill to the bottom of the filler
neck. Do not overfill. Wipe off
any spilled oil or fuel. Do not
store, spill or use gasoline near
an open flame.
IMPORTANT INFORMATION
Experience indicates that alcohol blended
fuels (called gasohol, ethanol or methanol)
can attract moisture which leads to
separation and formation of acids during
storage. Acidic gas can damage the fuel
system of an engine while in storage. To
avoid engine problems, the fuel system
should be emptied before storage of 30
days or longer. Drain the gas tank, start the
engine and let it run until the fuel lines and
carburetor are empty. Use fresh fuel the
next season. See Storage Instructions for
additional information. Never use engine or
carburetor cleaners in the fuel tank or
permanent damage may occur.
WARNING!
The engine and the exhaust
system, become very hot during
operation.
Risk for burns if touched.
Allow engine and exhaust
system to cool at least two (2)
minutes before refueling.