Filter
Top Products
30
CARE AND MAINTENANCE
CUTTER BLADE MAINTENANCE:
CAUTION Stop engine and remove ignition key for
safety. Wear heavy, thick gloves when
holding onto cutter blade, avoid the sharp
edge of the blade.
Blades should be discarded when worn excessively.
Check sharpness of mower blades after every 10
hours of operation. Observe proper blade position prior
to removal.
1. Safely raise front of mower.
2. Hold or block blade from
turning.
3. Loosen blade bolt and
remove blade.
4. When replacing blade,
tighten blade bolt securely.
Refer to diagram. Be sure
blade iscentered on pilot
before tightening bolt to 60
ft. lbs.
DANGEROUS!
DO NOT USE
BLADE IN THIS
CONDITION!
When notch starts,
discard blade
New Blade