Filter
Top Products
36
CARE AND MAINTENANCE
BELTS:
Check belts every 50 hours. Replace any belts found to be
in poor condition.
BELT TENSION:
Engine to Mower Deck Belt: P/N 6111 (50”)
P/N 6938 (60”)
The engine to mower deck drive belts are automatically
held in proper tension by springs which push the deck
assembly forward and do not require any additional
adjustment to be made.
Mower Deck Serpentine Belt: P/N 1300 (50”)
P/N 6939 (60”)
Refer to illustration for adjustment procedure.
Idler Weldment
“L” Rod
Idler Shock Mount
Hex Nut
5/8”
Tighten or
loosen hex
nut to
achieve this
demension
Note: Belt deflection or movement should be approximately 1/4” when
measured at mid-point between pulleys. Periodically inspect both belt
and idler systems.