Filter
Top Products
13
SPECIFICATIONS
Model ZTR 3303
CHASSIS: Twin 12 gauge side frames and 7 gauge
transmission andengine base plate.
BODY: All body parts made of rotational molded polyethylene.
Front body contains access panel for battery service.
Seat tilts forward to allow transmission service.
MOWER DECK: 11 GA stamped steel construction.Single 30 cut blade.
Cut height approximately 1-4 via 7-position lift handle
BLADE DRIVE: Mechanical; hand lever engagement
TRANSMISSION: Each rear wheel is independently driven by chain and
sprockets through a friction mechanical drive.
ENGINE: 11 HP Briggs & Stratton Intek, 4-Cycle, Single Cylinder,
Overhead Valve, Air-Cooled, Gasoline, Vertical Shaft, Cast
Iron Cylinder, AVS (Anti-Vibration System)
STARTING SYSTEM: Electric by key switch operation with safety interlocks
on parking brake and blade drive.
TIRES: Front 11 x 4.00-5 ribbed tread.
Rear 16 x 6.50-8 Turf Trac R/S tread
RECOMMENDED Front 16-21 PSI
TIRE PRESSURE: Rear 8-14 PSI
CAPACITIES: Fuel 2.0 gallons
Engine 1.25 quarts
DIMENSIONS: Width 32.5 outside rear wheel measurement
Height 32.0 to top edge of seat
Length 65.5 hitch tab to front bumper
Weight 430 lbs.
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE