Filter
Top Products
CONTROLS
Located on control panel above and to operators right.
To engage the mower blades, release parking brake by moving brake bail downward until
catch stop latch is fully engaged.
Grasp left control handle grip with enough pressure to depress built in safety switch. If
constant pressure is not maintained on either handle grip when blade drive is engaged,
engine will stop.
Using right hand, lift blade drive switch up and push forward.
To disengage blades, pull switch backward. Switch is clearly marked "ON and OFF".
MOWER DECK CUT HEIGHT LIFT LEVER:
Located to the right of operator.
Controls the cutting height.
Seven positions of adjustment.
Move lever in and forward to lower.
Move lever in and back to raise.
NOTE: Always use high position for transport.
CIRCUIT BREAKER:
Located on control panel to operator's right.
Protection of the electrical system is by (1) 15 amp circuit breaker.
If circuit breaker trips, push button to reset.
If this condition repeats, consult dealer for inspection and repair.
BLADE DRIVE:
Page 12