Dimension One Spas Aurora II Hot Tub User Manual


 
Note: 1. Subject to change without notice.
Specification, Aurora II
Doc-1513 Rev -B
Rev Date: 4/6/07
Aurora II Specifications
Dimension One Spas
Aurora II
83 1/4 in [211 cm]
Shell
See Caution
82 3/4 in [210 cm]
Skirt
80 1/2 in [204 cm]
Pedestal
Base
Top View of Spa
THE EDGES OF SPA BASE.
SUPPORTED CONSISTENT WITH
ON BOTTOM OF SPA, TO BE
THIS 3 FOOT SQUARE AREA,
12 in [30 cm]
Hose Bib/
Water Drain
26 1/2 in [67 cm]
Recommended location for
Electrical
Inlet
19 23/32 in [50.10 cm]
30 23/32 in [78 cm]
52 17/32 in [133 cm]
63 17/32 in [161 cm]
Vent
Control
Panel
See Note 5
Equipment
Compartment
Vent
Vent
Control Panel
Spa Lip
Pedestal Base
Hose Bib/
Water
35 1/2 in [90 cm]
32 in [81 cm]
3 1/2 in [9 cm]
16 in [41
66 3/4 in [170 cm]
Door Extends
Under Spa Lip
83 1/4 in [211 cm]
81 in [206 cm]
R16 in [R41 cm]
Optional stereo
Sub-woofer location
stereo speaker location
(optional)
stereo speaker location
(optional)
2. Engineering specs may differ slightly from brochure.
3. For E-Z lifter installation allow 18” (45.7cm) clearances on the backside of the spa.
4. Alternative cabinets may add significant weight. Ask your dealer for exact details
5. This is the approximate location for drilling a hole if you must bring the power line in through the bottom of the spa.
Be careful not to puncture a plumbing line inside the equipment compartment(drill from the inside compartment out).
Page 2 of 2
Architectural Specification
Caution:
Due to manufacturing tolerances there could be some
minor differences between the actual spa and the drawing above.
If site planning is critical to such tolerances, be sure to measure your actual spa.