Filter
Top Products
If you have a portable device other than a Digital Camera and would like to use the ACD-100
to power it up, then use the following guidelines:
1. Your device must be rated between 3V and 10V DC and no more than 2.5 Amp
(2500mAh) of current.
2. Use the chart below (FIGURE 2) to determine the output current from the ACD-100.
3. The ACD-100’s output current must be equal to or greater than the current your
portable device requires. Remember: 1.5Amp = 1500mAh, 2Amp = 2000mAh.
4. If the exact Voltage for your device is not listed on the chart below, and is under 10V,
then try setting the Voltage Dial to the nearest Voltage, using the lower Voltage first.
5. If the device does not power up, be sure to disconnect the Pin Connector from the
device, reset the Voltage Dial to the next higher setting and then reconnect your
device.
6. DANGER: Do not continue trying higher Voltage settings as this may result in damage
to your device and / or the ACD-100.
7. Mizco International, Inc. is not responsible for end user setting the Voltage above a
camera’s or device’s requirement level. Mizco’s warranty does not extend to misuse of
the ACD-100.
ACD-100 Voltage Dial ACD-100 Electrical Specifications
Voltage Amperage
3.0 Volts 1.5 Amp
3.4 Volts 2.5 Amp
4.5 Volts 1.5 Amp
5.0 Volts 2.0 Amp
6.0 Volts 2.0 Amp
Figure 1 6.5 Volts 2.5 Amp
7.0 Volts 2.0 Amp
8.4 Volts 1.3 Amp
9.0 Volts 1.6 Amp
FIGURE 2
PRECAUTION:
1. Do not expose this product to water, rain or moisture.
2. Make sure the ACD-100 is not plugged in when setting the Voltage and/or changing the
Pin Connector.
3. If traveling abroad, do not attach any voltage converters to this adaptor.
4. Make sure you know your camera’s or device’s Voltage requirement. Do not set the
Voltage to a higher setting than is required by your camera or device as this may result in
damage to your camera, the device or the ACD-100.
5. Mizco International, Inc. is not responsible for end user setting the Voltage above a
camera’s or device’s requirement level. Mizco’s warranty does not extend to misuse of
the ACD-100.
3.4V
3V
9V
8.4V
6V
6.5V
7V
5V
4.5V