Filter
Top Products
ENGLISH
37
• Air vents often cover moving parts and
should be avoided. Loose clothes, jewelry or
long hair can be caught in moving parts.
• Threaded mounting of accessories must match
the grinder spindle thread. For accessories
mounted by flanges, the arbor hole of the
accessory must fit the locating diameter of
the flange. Accessories that do not match the
mounting hardware of the power tool will run
out of balance, vibrate excessively and may
cause loss of control.
• The grinding surface of the centre depressed
wheels must be mounted below the plane of
the guard lip. An improperly mounted wheel
that projects through the plane of the guard lip
cannot be adequately protected.
WARNING: When not in use, place
tool on its side on a stable surface
where it will not cause a tripping
or falling hazard. Serious personal
injury may result.
Residual Risks
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of personal injury due to flying particles.
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.
– Risk of dust from hazardous substances.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
DATE CODE POSITION (FIG.1)
The date code (o), which also includes the year of
manufacture, is printed into the housing.
Example:
2012 XX XX
Year of Manufacture
Package Contents
The package contains:
1 Mortar raking motor
1 Side handle
1 Wrench
1 Universal connector
1 125 mm Mortar-raking shroud
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g.1, 2)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
FIG.1
a. Spindle lock button
b. Spindle
c. Side handle
d. Anti-lockup backing flange
e. Threaded clamp nut
f. Dust ejection system (DES)
g. Slider switch
FIG.2
h. Dust port
i. Clamp adjusting screw
j. Depth of cut shoe
k. Depth of cut shoe locking knob
l. Cornering door locking lever
(locks and unlocks cornering door)
m. Cornering door
(opens and allows cutting of an inside corner)
n. Clamp lever
INTENDED USE
The DWE46101 heavy-duty slot cutter has been
designed for professional cut-off applications.
Your mortar raking shroud has been designed
for professional mortar raking applications. It is
not intended for use with metal or wood. Using
the appropriate grinder, wheel and dust extractor
vacuum, it can be used to remove the vast majority
of static and airborne dust which without the