Filter
Top Products
10- ENG
D28921
A. Connect only to properly grounded outlet. Do not remove grounding pin.
B. Inspect cord before using. Do not use if cord is damaged.
C. Keep all connections dry and off the ground.
D. Do not touch plug with wet hands.
E. The pressure washer is provided with a ground-fault circuit interrupter built into the power
plug. If replacement of the plug or cord is needed, use only identical replacement parts.
Contact Customer Service for proper replacement parts.
Extension cords are not recommended unless they are plugged into a receptacle protected by a
ground fault circuit interrupter. Any extension cord used should be 14 AWG and no longer than 50
feet to prevent excessive voltage loss. Use only extension cords intended for outdoor use. These
extension cords are identified by a marking “Acceptable for use with outdoor appliances; store
indoors when not in use”.
4.1 START-UP PROCEDURE
1. Make sure water supply is connected and turned on.
2. Make sure the unit is plugged in and the GFCI HAS BEEN RESET.
3. Release gun safety if locked.
4.0 OPERATING INSTRUCTIONS
Risk of injection or injury. Do not direct discharge stream at persons.
A. Safety lock “locked”
B. Safety lock “unlocked”
4. To allow air to escape from the hose, squeeze trigger on the gun until there is a steady stream
of water.
5. Remove any dirt or foreign matter from the gun outlet and the male connector of the wand.
6. Insert the requested wand into the gun’s quick connect coupling by pushing firmly and twisting
wand ¼ of a turn to lock into place.
NOTE: Make sure wand is locked.