Filter
Top Products
11 - ENG
A16064
*
The high pressure spray from your pressure washer is
capable of causing damage to surfaces such as wood,
glass, automobile paint, auto striping and trim, and delicate objects such as
fl owers and shrubs. Before spraying, check the item to be cleaned to assure
yourself that it is strong enough to resist damage from the force of the spray.
Nozzle Color Red Yellow Green White Black
Spray
Pattern
0º
15º
25º 40º low pressure
Uses
powerful
pinpoint for
very intense
cleaning
intense
cleaning of
small areas
intense
cleaning of
larger areas
covers wide
areas of
cleaning
applies
cleaning
solutions
Surfaces *
Metal or
concrete
DO NOT use
on wood
metal,
concrete, or
wood
metal,
concrete, or
wood
metal,
concrete,
wood, or vinyl
metal,
concrete,
wood, or
vinyl
HOW TO APPLY
CHEMICALS/CLEANING
SOLVENTS
Applying chemicals or cleaning
solvents is a low pressure operation.
NOTE: Use only soaps and chemicals
designed for pressure washer use. Do
not use bleach.
To Apply chemicals:
1. Press chemical
hose onto
barbed fi tting
located near high
pressure hose
connection of
pump as shown.
2. Place other end of chemical
hose with fi lter on it into container
holding chemical/cleaning
solution.
NOTE: For every 7 gallons (26.5
liters) of water pumped 1 gallon
(3.8 liters) of chemical/cleaning
solution will be used.
Barbed
Fitting
3. Install low pressure (black)
nozzle into quick connect fi tting
of spray wand, see How To Use
Spray Wand paragraph in this
section.
4. After use of chemicals, place
chemical hose into container of
clean water and draw clean water
through chemical injection system
to rinse system thoroughly. If
chemicals remain in the pump
it could be damaged. Pumps
damaged due to chemicals will
not be covered under warranty.
NOTE: Chemicals and soaps will not
siphon when spray wand is in the high
pressure setting.