Filter
Top Products
23
STOPPING ENGINE
IMPORTANT:
The engine speed is preset. The throttle is locked in preset posi-
tion. Do not adjust throttle.
Follow the steps below to stop engine.
1. Remove all electrical loads from generator (see Disconnecting Electrical
Loads, page 22). Remove electrical loads one at a time.
2. Let engine run for two or three minutes after removing electrical loads. This
lets engine cool slightly.
3. Turn engine switch to the OFF position (see Figure 19).
4. Turn fuel valve lever off. Do this by moving valve lever fully to the left (see
Figure 20).
OPERATION
Continued
HONDA
OFF
ON
START
ENGINE SW
CIRCUIT
BREAKER
ON/push OFF
Engine Switch For
Model MGH7000
Engine Switch For All
Models Except MGH7000
Figure 19 - Engine Switch In OFF Position
Figure 20 - Fuel Valve Lever Off
Fuel Valve Lever
(Off Position)
OFF
ENGINE SW
ON