Filter
Top Products
8
ASSEMBLY
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
STAND
(FOR MODEL SS350LS ONLY)
NOTE: THE ASSEMBLY OF THIS STAND WILL USE
M8X16MM CARRIAGE HEAD SCREWS AND M8
FLANGED HEX NUTS. KEEP THE HEAD OF THE
CARRIAGE HEAD SCREWS TO THE OUTSIDE OF THE
STAND WITH THE FLANGED HEX NUTS TO THE
INSIDE OF THE STAND.
NOTE: MAKE SURE THAT THE SHELF ON THE
BRACES ARE ON TOP WHEN ATTACHING THE
BRACES TO THE LEGS.
Assemble stand as shown in Fig. 2 using parts shown in
Fig. 1. The braces, legs and feet are labeled the same in
both illustrations. Insert the M8x1.25x16mm carriage
head screws through legs and braces then secure with
the M8x1.25 flange hex nuts. Loosely tighten hardware
at this time.
NOTE: MAKE SURE THAT THE DIMPLES ON THE
LEGS (A) FIG. 2 ARE ENGAGED WITH THE HOLES
ON THE BRACES (B).
Fig. 2
SCROLL SAW TO STAND
(FOR MODEL SS350LS ONLY)
2
2
3
3
4
4
5
6
7
7
1. Place the scroll saw on the top braces of the stand
Fig. 3.
2. Align the three holes (A) Fig. 3, (two of which are
shown), with the three holes in the top of the stand.
3. Place a 5/16" flat washer on a 5/16-18x1½" hex
head screw, insert the screw through the hole in the
base of the scroll saw and the hole in the stand. Place a
5/16" flat washer, 5/16" lockwasher and thread a 5/16-
18 hex nut onto the screw. Repeat this process for the
two remaining holes in the scroll saw base and stand.
4. Tighten all stand hardware securely.
Fig. 3
A
A
A
B