Filter
Top Products
11
TILTING THE TABLE
The table on your scroll saw can be tilted 45° to the left
for bevel cutting operations by removing the dust cup as
shown in Fig. 24 and loosening table lock knob (A) Fig.
10, tilt the table to the desired angle indicated on degree
scale (B) Fig. 11 and tighten lock handle (A) Fig. 10.
When bevel cutting, the holddown (B) Fig. 12, can be
adjusted to lay flat on the stock by loosening screw (C)
and tilting the holddown (B). Then tighten screw (C).
Fig. 10
A
Fig. 11
B
Fig. 12
C
B
Fig. 13
B
A
Fig. 14
B
C
ADJUSTING THE TABLE
1. Loosen table lock knob as shown in Fig. 10 and
move the table all the way to the right until angle
indicator shown in Fig. 11 is on “0”.
2. Using a square that includes a level, check to see if
the table is level (A) Fig. 13, and is 90° to the saw blade
(B), as shown.
3. If the table is not at 90° to the blade, adjust the table
making certain screw (B) Fig. 14, contacts bottom of
table surface when table is 90° to the blade. To make
this adjustment loosen nut (C), turn screw (B) in or out
the desired distance and tighten nut (C).
Note: After adjusting table, reposition the pointer (B) Fig.
11 to "0" degrees. Loosen the screw (A) Fig. 11 and
adjust pointer (B) to “0” degree mark and retighten
screw (A).
A