Filter
Top Products
12- ENG
A00543
4. Remove the high-pressure nozzle
from the spray wand. Remove any
obstructions with the nozzle
cleaning tool provided and
backflush with clean water.
5. Direct water supply into spray
wand to backflush loosened
particles for 30 seconds.
6. Reassemble the nozzle to the
wand.
7. Reconnect spray wand to gun and
turn on water supply.
8. Start pressure washer and place
spray wand into high pressure
setting to test.
HOW TO CLEAN THE WATER
INLET FILTER
This screen filter should be checked
periodically and cleaned if necessary.
1. Remove filter by
grasping end and
removing it from
water inlet of pump
as shown.
2. Clean filter by flushing it with
water on both sides.
3. Re-insert filter into water inlet of
pump. NOTE: Cone side faces
out.
NOTE: Do not operate pressure
washer without filter properly installed.
HOW TO REMOVE THE
WHEELS
1. Using a 1/8" hex
head wrench
loosen set screw
in hub collar.
2. Slide hub collar
from axle and remove the tire.
To Check Oil:
1. Remove
dipstick/oil
plug from
pump and
wipe clean.
2. Insert
dipstick/oil
plug fully
into pump, then remove it.
3. Oil level is correct when oil covers
the lower 1/2 inch of end of
dipstick/oil plug.
How To Change Pump Oil
1. Loosen dipstick/oil plug.
2. Place a container under the oil
drain plug.
3. Remove oil drain plug.
4. After oil is drained replace oil drain
plug. Tighten securely.
5. Remove dipstick/oil plug and fill with
13.5 oz of 30W non detergent oil.
6. Replace dipstick/oil plug and
tighten securely.
Dipstick/oil plug
PUMP
NOTE: The pump was filled with oil at
the factory.
1. Change pump oil after the first ten
(10) hours of operation and every
fifty (50) hours thereafter.
Oil Drain Plug
NOZZLE CLEANING
If the nozzle becomes clogged with
foreign materials, such as dirt,
excessive pressure may develop. If
the nozzle becomes partially clogged
or restricted, the pump pressure will
pulsate. Clean the nozzle immediately
using the nozzle kit supplied and the
following instructions:
1. Shut off the pressure washer and
turn off the water supply.
2. Pull trigger on gun handle to
relieve any water pressure.
3. Disconnect the spray wand from
the gun.
Filter Screen