Filter
Top Products
20- ENG
D27918
DUAL TANK CLEANING SYSTEM
1. Turn control valve knob to the down (off) position.
2. Remove cleaning solution hose at chemical injector and pull through rear
shroud.
3. Place end of cleaning solution hose into a suitable container to drain
cleaning solution.
4. Turn control valve toward tank to be drained.
5. Repeat steps 3-4 to drain second tank.
6. Turn control valve knob to the down (off) position.
7. Fill tanks with clean water.
8. Turn valve toward tank and drain water from tank. Repeat on second tank.
NOTE: This will rinse cleaning solution tanks.
9. Feed cleaning solution hose between shroud and wheel bracket making sure
it is routed over the axle as shown. Reconnect cleaning solution hose to
chemical injector for future use.
Control Valve Knob
Axle
Hose