Filter
Top Products
9- ENG
D27665
4. Connect gun to high pressure
hose. Tighten securely. See figure
6.
To reduce the risk of
electrocution, keep
all connections dry and off the
ground. Do not touch plug with wet
hands. Do not use if cord is
damaged.
5. Plug the unit into an appropriate
outlet that is properly installed and
grounded in accordance with all
local codes and ordinances. See
the GROUNDING paragraph.
6. Connect the high pressure hose to
the water outlet on the unit. The
water outlet is marked OUT. See
Figure 7.
7. Assemble quick-connect adapter
to water inlet. See Figure 8.
8. Connect the quick-connect to the
water supply hose. See Figure 8.
9. Connect quick-connect to quick
connect adapter at the water inlet.
See Figure 8.
Figure 7
Figure 8
STARTING YOUR PRESSURE
WASHER
NOTE: Make sure water supply is
turned on.
1. Disengage the safety catch as
shown in Figure 9. Depress trigger
to allow air to escape and to
discharge residual pressure in the
pipes.
2. With the trigger
depressed, place the
ON-OFF switch in the
On position. When
starting motor, always
keep the trigger depressed.
RECOMMENDED CLEANING
●
On vertical surfaces, work from the
bottom upwards.
●
Let the detergent sit for 1-2
minutes, DO NOT allow detergent
to dry.
●
To rinse detergent, apply the high
pressure jet, keeping the nozzle at
least 10 in. from the surface, work
from the bottom up.
Figure 9
Figure 6
NOTE: The water supply must
provide a minimum of 2 gallons per
minute.
10. Make sure high pressure hose and
water supply hose are securely
connected.
11. If you are applying a chemical or
cleaning solution see How To Use
Chemical Application Unit in
this section.
12. Turn water supply on.