Filter
Top Products
7- ENG
A09733
d. Snap spray
wand (c)
in place
on surface
cleaning
guide
e. Rotate
"J" hook
over spray
wand and
tighten knob
securely.
f. See To Use Spray Wand
paragraph in the Operation
section of this manual to
choose and assemble the
correct nozzle for the job to
be performed.
6. Connect wand to gun. Tighten
securely.
4. Attach high
pressure hose
to gun. Tighten
securely.
3. Place handle assembly onto
frame, depress the snap buttons,
and slide the handle assembly onto
the frame until snap buttons snap
into place.
NOTE: The high pressure pump was
filled with oil at the factory. The oil in
the high pressure pump was designed
to last the life of the pump. If there is
a problem with the pump contact an
Authorized Service Center.
7. Add engine oil (supplied)
to engine. Refer to Engine
Owners Manual supplied by
engine manufacturer for correct
procedure.
NOTE: There will be a slight amount of
oil in the engine from factory testing.
5. To Assemble "Water Vroom"
surface cleaning guide.
NOTE:
If not using the "Water Vroom"
surface cleaning guide proceed
to step 6.
a. Loosen knob
(a) and rotate
"J" hook (b)
down and
out of the
way.
b. Slide spray
wand (c)
through
opening
in surface
cleaning
guide.
IMPORTANT: Make sure nozzle is
removed before assembling surface
cleaning guide.
c. Adjust spray wand to
desired height needed for
job to be performed.
a
b
c
a
b
c
The shipping plug
must be removed
and replaced with the dipstick/oil
plug before operating pressure
washer.
8. Using an 11/16"
wrench, remove
shipping plug
from pump
by turning it
counterclockwise. Discard plug.
9. Remove dipstick/oil plug from
plastic bag and install into pump,
tighten securely.