Filter
Top Products
DISARMING
To disarm the P205, simply switch on the vehicle's engine.
The small transponder tag attached to your key chain will
come in close proximity to the receiver antenna located below
the ignition switch. The P205 will decode the signal from the
tag and disarm. The red status LED will extinguish and the engine
can be started. If the engine is not started within 39 seconds the P205
will automatically re-arm.
ARMING
The P205 will automatically arm within 39 seconds of the ignition being
switched off.
ENGINE IMMOBILISATION
When the system is armed the engine is immobilised. The two independent,
normally open circuits of immobilisation ensures the engine is starved of either
fuel or spark. Immobilisation points vary from vehicle to vehicle; common
engine kill places include fuel injection, fuel pump, fuel cut-off solenoids, main
ignition feed, low-tension distributor supplies and starter motor solenoids etc.