Filter
Top Products
10
TRIMMER ASSEMBLY
The trimmer is partly disassembled for ease of
shipment and must be assembled before it can be
used for the first time.
WARNING
Because of the increased risk of accidents
the powerhead must not be started while it
is detached from the trimmer.
1
1. Mount the loop handle (Ref. 1) .
A. MOUNTING THE LOOP HANDLE:
2. Position the clamp (Ref. 2) in the loop handle
(Ref. 1).
3. Place both parts on the drive tube (Ref. 5).
4. Position the clamp (Ref. 3).
5. Insert the screws (Ref. 4) hand tight.
1
5
2
3
4
B. MOUNTING THE DEFLECTOR:
1. To mount the deflector, lay the trimmer on its
back with the cutting tool head facing upward.
1
2
2. Place the deflector (Ref. 1) inside pointing
upward, on the bracket already fitted to the drive
shaft. Fit the plate (Ref. 2) on the inside of the
deflector and line it up. Insert the four screws
and tighten them down.
3. When using the nylon line trimmer, attach the
deflector (B) with a chopper blade on your
brushcutter in order to keep the line at the proper
length. Failure to follow this procedure may
damage your brushcutter.
WARNING
To reduce the risk of injury from thrown objects
or blade contact, never operate the trimmer
without a properly mounted deflector.
C. MOUNTING THE CUTTING TOOL:
1. Install the nylon line trimmer head or the cutting
blade as illustrated.
6. Line up the loop handle and tighten the screws
firmly.
(
A
)
(
B
)