Filter
Top Products
7
DECAL INFORMATION
WARNING
LOCATE THE SAFETY DECALS ON YOUR TRIMMER. MAKE
SURE THE DECALS ARE LEGIBLE AND THAT YOU UNDER-
STAND AND FOLLOW THE INSTRUCTIONS ON THEM.
DEFLECTOR DECAL:
SHAFT DECALS:
This trimmer can be can be
dangerous and cause serious injury
if improperly used. To reduce injury
risk to operator, helpers and
bystanders, read and understand the
Operator's Manual.
Blindness can occur from objects
that are thrown or ricochet even with
a shield in place. Operators, helpers
and by-standers must wear ANSI
Z87.1 approved eye protection.
Always wear hearing protection
when operating a trimmer.
Prevent accidental contact
with the trimmer and any
cutting attachment. Maintain a
50 ft. (15m) radius, DANGER
ZONE surrounding the
operator. ONLY the operator,
dressed in proper protective
clothing should be in the
DANGER ZONE.
SHAFT DECALS: (Continued)
KICKOUT
Beware of KICKOUT (blade thrust)
when using blades. Special
precautions are necessary for blade
operation, see your Operator's
Manual. Install ONLY Cub Cadet
Commercial approved blades on ST
model trimmers equipped with
proper blade shield, loop handle,
shoulder harness, blade collar, nut
and cotter pin.
The blade/cutting attachment does
not stop immediately after releasing
the throttle. Keep hands and feet
clear of the blade/cutting attachment
unless the engine is shut off and the
cutting attachment is not moving.
INSPECT BLADES BEFORE USE.
DO NOT USE DAMAGED, CRACKED, BENT,
DULL, OR IMPROPERLY SHARPENED BLADES.
Do not remove shields or decals, modify the unit or
install unapproved attachments or parts. Approved
attachments and replacement Operator's Manuals
are available from your Cub Cadet Commercial
dealer or by writing:
CUB CADET CORPORATION
P.O.Box 368023, Cleveland,OH 44136-9723