Filter
Top Products
19
Deck Spindles
Grease fittings can be found on the top of each deck
spindle shaft. See Figure 14. Lubricate with 251H EP
grease or an equivalent No. 2 multi-purpose lithium
grease. Using a grease gun, apply two strokes
(minimum) or sufficient grease to flush old grease and
dirt out of the spindle shaft.
Figure 14
Front Wheels
Each of the front wheel axles and rims is equipped with
a grease fitting. See Figure 15. Lubricate with a grease
gun after every 25 hours of tractor operation.
Figure 15
SECTION 8: SERVICE
Tires
WARNING: Never exceed the maximum
inflation pressure shown on the sidewall of the
tire.
The recommended operating tire pressure is
approximately 10 psi for the rear tires and 14 psi for the
front tires.
Refer to the tire sidewall for exact tire manufacturer’s
recommended or maximum psi. Do not overinflate.
Uneven tire pressure could cause the cutting deck to
mow unevenly.
Head Lamps
WARNING: If the engine has been recently
run, the engine, muffler and surrounding
metal surfaces will be hot and can cause
burns to the skin. Allow the tractor to cool and
use caution when changing the lamp bulbs.
Replace headlight bulbs as follows:
• Lift the hood and locate the headlight wire harness
and lamp sockets
• To remove the bulb & socket from the reflector
housing, simply grasp the socket and gently rotate
it 1/4 turn clockwise.
• After replacing the bulb, align the tab of the socket
with the notch of the reflector and gently rotate it 1/4
turn counterclockwise.
Cutting Blades
WARNING: Be sure to shut the engine off,
remove ignition key, disconnect the spark plug
wire(s) and ground against the engine to
prevent unintended starting before removing
the cutting blade(s) for sharpening or
replacement. Protect your hands by using
heavy gloves when grasping the blade.
WARNING: Periodically inspect the blade
adapter and/or spindle for cracks or damage,
especially if you strike a foreign object.
Replace immediately if damaged
.
The blades may be removed as follows.
• Remove the deck from beneath the tractor, (refer to
Cutting Deck Removal on page 21) then gently flip the
deck over to expose its underside.
Grease Fitting
Axle Grease Fitting
Rim Grease Fitting