Filter
Top Products
11
MAINTENANCE
D. LUBRICATION CHART: See Figures 3, 4 & 5 for Item Location
E. ENGINE MAINTANENCE:
For detailed maintenance instructions for the engine on your
mower, see the separate engine manual packed with your
mower.
F. MOWER MAINTANENCE:
1. TO CHANGE A BLADE: (See Figure 6.)
a. Remove the deck cover.
b. Tip the mower back and block up the front of the
deck.
c. Place one wrench on the hex head bolt under the
blade. Use a second wrench to remove the locknut
on top of the spindle pulley.
d. Remember the number of blade spacers both
above and below the spindle.
e. Remove the long (9-1/2") blade bolt, the flat
washer, the blade and the blade spacers.
f. To replace the blade, reverse the above procedure.
Be careful to replace the blade spacers correctly
above and below the spindle.
2. TO SHARPEN A BLADE:
a. To sharpen a blade, clamp the blade in a vise and,
using a flat mill file, carefully file the cutting surface
on each end of the blade to a sharp edge.
g. Blades with severe nicks or dents that cannot be
removed by filing should be replaced.
h. After sharpening, check the balance of the blade by
placing the blade on a blade balancer fulcrum
device.
i. If the blade dips on one end, file stock off of the
cutting surface on that end. NOTE: If a blade
cannot be easily balanced, replace it.
Figure 3
Figure 4
Figure 5
3. TO CHANGE THE DRIVE BELTS:
a. Make sure the blade clutch is disengaged.
b. Remove the deck cover.
c. Remove the cap screw which serves as a belt
guide and is mounted in the idler pulley arm.
(Item J, Figure 7.)
NUMBER OF
GREASING
POSITIONS ITEM DESCRIPTION
32” & 36” 48” & 52”
DAILY 2 3 A Cutter Blade Spindle Bearings
EVERY
40
HOURS
2
2
1
2
2
1
2
2
2
2
2
2
1
2
B
C
D
E
F
G
H
Caster Wheel Bearing
Caster Wheel Pivot Shafts
Deck Idler Pulley Pivot Arms
Drive Wheel Bearings
Brake Lever Pivots
Blade Clutch Bellcrank Pivot
Transmission-Jackshaft Couplers
G
H